DBH 5598 radial shaft seal — 44.45 x 53.97 x 4.84

DBH 5598 is a reference of radial shaft seal, within Seals. Request a quote for 5598 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DBH 5598 radial shaft seal is a lip seal designed to block the passage of lubricant and prevent the ingress of contaminants on rotating shafts. With dimensions of 44.45 mm shaft diameter, 53.97 mm housing bore and 4.84 mm height, and an Mz design, it is used in equipment where axial space is limited and a reliable barrier is required. MR Accesorios Industriales supplies this brand and advises you so you choose the correct seal for your application.

This item is a DBH radial shaft seal, identified by its designation 5598. Its dimensions are 44.45 mm shaft diameter (d), 53.97 mm housing bore diameter (D) and 4.84 mm height (h). The Mz design corresponds to a specific configuration of lip and body that defines its behavior in service. Being a low-profile seal, it is intended for assemblies where housing depth is limited and effective sealing is needed without sacrificing space.

Typical applications for a seal such as the DBH 5598 include gearboxes, pumps, electric motors, transmission shafts and rotating equipment in general. Its function is to retain oil or grease inside the assembly and block dust, water or particles that could wear bearings and gears. It is a critical part in industrial maintenance, since its failure can cause leaks, loss of lubricant and major damage to the machine.

To correctly select and install this seal, verify that the shaft and housing dimensions match those of the manufacturer: 44.45 mm and 53.97 mm respectively. The 4.84 mm height must fit into the available depth. During installation, lubricate the lip, avoid damaging it with sharp edges and make sure the shaft has no burrs or excessive wear. The Mz design may require a specific orientation; consult the manufacturer's data sheet if you have doubts about the lip direction.

If you need a seal equivalent to the DBH 5598, the most practical approach is to send us the full code, a photo of the part or the dimensions measured with a caliper. With that data we can look for alternatives within the same category of radial seals. We can also guide you on compatibility with other brands, always respecting the dimensions and design type. Do not improvise with approximate dimensions: an incorrectly sized seal does not seal properly and can fail prematurely.

At MR Accesorios Industriales we supply the DBH brand as part of our line of seals and oil seals. If you want to request a quote for the 5598 seal, send us the code on WhatsApp and we will reply promptly. We can also advise you on installation and precautions so the repair goes right the first time.