Radial shaft seal DBH 5426 — 32.00 x 47.00 x 10.00

DBH 5426 is a radial shaft seal reference, within Seals. Request a quote for 5426 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 5426 oil seal is a radial shaft seal with a 32 mm shaft diameter, 47 mm housing diameter and 10 mm height, in the Lx design. It is used to retain lubricant and exclude contaminants in rotating equipment, protecting bearings and bushings. It is a common replacement part in industrial maintenance, where correct fit and material selection determine service life. MR Accesorios Industriales carries this brand and advises you so you order the right size.

This item is a DBH 5426 radial shaft seal, identified by its 5426 designation. Its dimensions are 32.00 mm shaft diameter, 47.00 mm housing diameter and 10.00 mm height. The Lx design corresponds to a single lip with spring, intended for rotating shafts with lubrication. The DBH nomenclature groups seals for general industrial use. If you need to confirm tolerances or lip material, this is checked against the manufacturer's data sheet before quoting.

Typical applications include gearboxes, centrifugal pumps, electric motors, conveyor rollers and power transmission equipment. In all cases, the seal prevents oil or grease leaks and blocks the entry of dust, water or particles. It is also used in agricultural and road machinery, where exposure to mud and vibration demands reliable sealing. It is a wear part that should be replaced at every scheduled teardown.

To install a radial shaft seal, check that the shaft has no burrs or wear and that the housing is clean and free of deformation. Lubricate the lip with the same grease or oil used in the equipment before inserting it. The Lx design handles moderate speeds and low pressures; if your application runs at high pressure or temperature, ask us about a suitable variant. Selection depends on shaft diameter, housing and the type of fluid to be retained.

If you cannot find the exact size or the 5426 code does not match your equipment, we can look for an equivalent or a nearby size within the same oil seal category. Send us the shaft diameter, housing diameter and height you need, or directly the code stamped on the old part. With that data we review alternatives from the DBH brand and other lines we carry, always respecting the critical dimensions of your machine.

To request a quote for the DBH 5426 oil seal, send the code by WhatsApp to MR Accesorios Industriales. You can also send a photo of the part or the measurements taken with a caliper. We reply with the quote and, if needed, with equivalent options. More than 80 years supporting industrial maintenance in Argentina allow us to guide you toward the best solution for your equipment.