DBH 1262 radial shaft seal — 41.27 x 62 x 9.65

DBH 1262 is a reference of radial shaft seal, within Seals. Request a quote for 1262 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DBH 1262 radial shaft seal is a lip seal designed to retain lubricant and exclude contaminants on rotating shafts. Its designation 1262 corresponds to a seal with a compact cross-section, with standardized dimensions for standard housings. It is used in gearboxes, pumps, electric motors and power transmission equipment, where reliable shaft sealing is critical to prevent leaks and extend the service life of bearings and gears. MR Accesorios Industriales supplies this reference as part of its line of seals and radial shaft seals.

The DBH 1262 is a radial shaft seal with the following dimensions: shaft diameter 41.27 mm, housing diameter 62.00 mm and height 9.65 mm. The Mx design indicates a single-lip configuration with a spring, suitable for single-direction rotation applications. The sealing lip, made of elastomer, works on the shaft through a slight interference that guarantees tightness. The outer metal case ensures a firm fit in the housing. This combination of dimensions and design makes it interchangeable with seals of similar dimensional characteristics.

Typical applications of this seal include gearboxes, centrifugal pumps, electric motors, compressors and belt or chain transmission equipment. In all these cases, the seal prevents the loss of oil or grease and protects the bearings from the ingress of dust, water or particles. It is also used in machine tools, mining equipment and agricultural applications, where working conditions demand seals resistant to wear and weather. Its compact size allows it to be installed in tight spaces without sacrificing performance.

To correctly select a seal such as the DBH 1262, verify that the shaft and housing dimensions match those stated. The shaft surface must have adequate hardness and roughness to prevent premature lip wear; a minimum hardness of 45 HRC and roughness Ra between 0.2 and 0.8 µm are recommended. The housing must be clean, free of burrs and with an entry chamfer so as not to damage the lip during installation. Lubricate the lip with the same oil or grease used in the equipment before installing. Avoid striking the seal and make sure it sits perpendicular to the shaft.

If you need a seal equivalent to the DBH 1262, contact us on WhatsApp. We can look for alternatives in other brands or configurations that fit your application. To speed up the inquiry, send the part number 1262 or the dimensions 41.27 x 62.00 x 9.65 mm along with a photo of the original seal if possible. Our technical team advises you to find the most suitable option, whether by dimensions, lip material or spring type.

If you have any questions about installation or compatibility, do not hesitate to ask us. Send the part number DBH 1262 on WhatsApp and we will reply promptly with the information you need for your equipment.