Radial shaft seal DBH 1235Vit — 70.00 x 100.00 x 13.50/15.00

DBH 1235Vit is a radial shaft seal reference, within Seals. Request a quote for 1235Vit via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 1235Vit radial shaft seal is a lip seal designed to stop lubricant from escaping and keep contaminants out of equipment with a rotating shaft. Its A 298 Bidi design allows use in applications where sealing must be effective in both directions of rotation or with pressure reversal. With dimensions of 70 mm shaft, 100 mm housing and a height of 13.50/15.00 mm, it is a common replacement part in gearboxes, pumps and electric motors.

This item is a seal from the DBH line, identified by the designation 1235Vit. Its nominal dimensions are 70.00 mm shaft diameter (d), 100.00 mm housing diameter (D) and a height (h) of 13.50/15.00 mm. The A 298 Bidi design corresponds to a double-lip seal with a bidirectional configuration, intended to contain lubrication and repel dirt from the outside. DBH is a brand that MR carries, so it is sourced through our supply network.

Typical applications for this seal include gearboxes, speed reducers, centrifugal pumps, electric motors and power transmission equipment in general. In all cases, the seal works on a rotating shaft and inside a machined housing, retaining oil or grease and blocking dust, water or particles that could damage bearings and gears. It is a wear part that should be replaced when leaks or abnormal noises appear.

For installation, check that the shaft and housing are clean, free of burrs and marks, and that the 70 mm and 100 mm dimensions match the equipment data sheet. The 13.50/15.00 mm height allows the seal to fit into cavities with a small shoulder or with axial retention. Lubricate the lip before inserting it and avoid striking it during installation. If the shaft shows wear, consider a nearby size or a seal with an auxiliary lip. The final selection must take speed, temperature and the fluid to be retained into account.

If you need an equivalent or a different size, the most practical approach is to send us the code 1235Vit or the current dimensions (shaft diameter, housing and height) along with a photo or sample of the original seal. With that data we can look for an alternative within the DBH line or other brands we carry, respecting the A 298 Bidi design or whichever corresponds to your equipment. We can also advise you if the space allows a different height.

To request a quote for this DBH 1235Vit seal or ask about a similar size, send us the code on WhatsApp at MR Accesorios Industriales. We will reply with the alternatives that best suit your application. More than 80 years supporting Argentine industry with sealing, bearing and power transmission solutions.